zfs create -V 10G tank/virtualdisk mkfs.ext4 /dev/zvol/fourth/virtualdisk zfs set compression=on fourth/virtualdisk
To create a sparse volume you add the -s parameter so that the previous command would look like this
Sparse = volume with no reservation / Thin provisioning
zfs create -s -V 10G fourth/virtualdisk
mount /dev/zvol/fourth/virtualdisk /mnt
Check available space on the filesystem:
df -h /mnt
Resize
zfs set volsize=20G tank/virtualdisk resize2fs /dev/zvol/tank/virtualdisk df -h /mnt zfs list
As mentioned, even if the volume is empty at the moment, space is preallocated, so it takes 20GB out of our pool. But even though it wasn’t initially created as a sparse volume, we can change it now
zfs set refreservation=none tank/virtualdisk zfs list
Tip: when using ext4 on a ZFS volume, you may notice that after deleting data in `/mnt`, the volume doesn’t reflect any gains in usable space. This is because, for efficiency, a lot of filesystems like ext4 don’t actually remove the data on disk, they just dereference it. Otherwise, deleting 100GB of information would take a very long time and make your system slow. This means that deleted files continue to exist in random blocks on disk, consequently on the ZFS volume too. To free up space, you would use a command such as `fstrim /mnt` to actually erase unused data in the ext4 filesystem. Only use the tool when needed, as to not “tire” the physical devices unnecessarily (although the numbers are pretty high these days, devices have a limited number of write cycles).
Don’t forget that a lot of the other ZFS-specific features are also available on volumes (e.g snapshots and clones).